|
|
 printable version
Dropping the pressure in the supply system
 | After performing the procedure described below in the pipelines will remain gasoline. Before disconnecting any fuel hose, take all necessary precautions. |
| - When the engine is running within the fuel supply path system is under pressure which persists for a sufficiently long period of time even after the ignition is switched off. Before disconnecting any of the components of the system, relieve the pressure in bar.
- Nissan is to recommend the use of depressurization diagnostic tool ?�Consult-II?�, but this operation can be carried out in another way.
- Disconnect the fuel pump circuit. To do this, remove the fuse (see chap. Onboard electric equipment) or remove assemblage of the rear seat (see. Chapter Body), open the service hatch and disconnect the connector assembly of the sensor supply of fuel, the fuel filter and fuel pump (see. Section Removal and installation of assemblage fuel pump, fuel filter and fuel gauge of a stock).
- Start the engine. After the engine stall spontaneously, to ensure completeness of pressure relief, rotate it several times a starter. If the engine fails to start, crank his starter for a few seconds. After finishing the procedure, turn off the ignition and the Dock Connector / install fuse.
- Remember that after the pressure drop / remove fuel from the power supply system at the start of the engine takes a little longer than usual - will rotate the crankshaft starter as long as the system pressure is restored, and fuel fill all gasoline pipe lines.
|
|
|
|
