 printable version
Service air intake system
Removal, installation and maintenance of the air filter element Service item The procedure is described in detail in Chapter Settings and maintenance. Refitting Withdrawal | - Disconnect the electrical wiring from the air flow meter.
- Release the clamp on top of the air cleaner housing to the bottom.
- Loosen the hose clamps and disconnect air flow meter from air.
- Remove the top half of the air cleaner housing and remove the filter element.
- Give fixing nuts and remove the lower half of the air cleaner housing from the vehicle.
|
|
Setting Installation is in the reverse order. After completing the installation of all components, run the engine and check for air leaks. Removal and installation of air duct Withdrawal | - Loosen the hose clamps to duct the air flow meter and the throttle body.
- Give screw (s) securing the silencer to the cylinder head cover.
- Mark and disconnect the hoses from the muffler.
- Remove the air duct assembly with a silencer from the vehicle.
- If necessary, loosen the clamp and remove the air hose from the muffler.
|
|
Setting Installation is in the reverse order. Make sure that the arrow on the duct sleeve during installation is aligned with point mark on the muffler. Removing and installing throttle body Withdrawal | - Remove the air duct.
- Disconnect the accelerator cable from the pull on the throttle.
- Drain the coolant, lowering the level below the level of the throttle body.
- Disconnect the throttle body cooling hoses.
from the throttle position sensor (TPS) and the gauge-switch of idling (the location of the throttle body and associated components shown in the accompanying illustration).
- Disconnect from the throttle vacuum hose.
- Give fixing screws and remove the throttle body gasket with the pump chamber and remove it from the vehicle.
|
|
Setting Installation is in the reverse order. | - Be sure to thoroughly remove all traces of the old gasket material from the mating surfaces of the pump chamber and the throttle body. If the throttle traces of coal deposits, remove them with a special composition for cleaning carburetors. Try to avoid ingress of cleaning fluid into the electrical component on the spindle.
- Before installing the throttle body, make sure the correct placement of the pad.
- Tightening bolts produce evenly in a diagonal manner, achieving the last stage of the required effort.
- Top up the coolant in the cooling system.
- Test the TPS, if necessary, make his adjustment.
- Adjust the accelerator cable.
- Start the engine and check for air leaks.
|
|
Removal, installation and adjustment of the throttle cable Refitting Withdrawal | - Remove the core from the cable pull on the throttle.
- Loosen the adjusting nut and release the cover of a cable from an arm.
- In the car pry the plastic sleeve cable and remove it from the top of the gas pedal arm. Release the cable core from the lever.
- Give bolts cable bracket.
- Pull the cable through the bulkhead engine compartment into the passenger compartment.
- Check the cable and its shell for signs of wear, the peg and other damages. If necessary, replace the cable.
|
|
Setting Installation is in the reverse order. | - When installing the cable avoid kinking and excessively bend it to avoid the peg.
- Track correctness of landing plastic sleeve cable in the lever throttle pedal.
|
|
Adjustment | - Make sure that the manual gas is completely released.
- Ask the assistant to squeeze the gas pedal completely.
- In the engine compartment by turning the adjusting nut until you get the throttle setting to fully open position. Tighten the adjusting nut.
- Release the pedal and check that the valve is fully closed, and the pedal has a free lift of about 1 ÷ 3 mm. Little slack should also have the core of a cable on the throttle. If necessary, repeat the adjustment.
|
|
|
