 printable version
Removing and installing bonnet
Withdrawal | - Lift the hood and secure it with emphasis.
- Cover the mud flaps of both wings with special lids or just old blankets to protect the paintwork. Pay particular attention to the protection placed at angles hood areas.
 | - Disconnect the fluid hose from the washing of a windscreen hose on the hood (see. Accompanying illustration).
|
- Marker plate circle loops, marking their location on the hood.
- Give bolts of fastening plates to the hood hinges, remove the washer. With the help of an assistant, remove the hood of a car.
|
|
Setting | - With the help of an assistant install the hood on the car, fixing it in front of emphasis.
- Screw bolts to the hood hinge plates (do not forget to install the washers under their heads). Align the hinge in accordance with applied during the dismantling of the landing labels, only then can tighten the screws.
- Ask the assistant to hold the hood latch in the open position drive cable, do close the hood.
- Check the location of the lateral edges of the hood with respect to the wings of the car and the rear edge with respect to the body panel.
- If necessary, loosen the adjustment bolts to the hood hinges and properly tweak the position of the hood.
- Check the operation of the bonnet. When you release the lock the hood should be slightly lifted abruptly, allowing the fingers to reach the latch lock.
- To adjust, loosen the lock screws (see. Accompanying illustration) and slide the lock in the required direction. Tighten the screws.
|
|
|
