REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Patrol (from 1988 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Patrol
		Introduction
		Troubleshooting
		Adjustment and routine maintenance
		Engine
		System of cooling, heating and air conditioning
		The power supply system and exhaust
		Systems for reducing emissions
		Systems of an electric motor
		Transmission
		Clutch
		Brakes
		The front and rear axles, chassis and steering
			Front axle and suspension
			The front suspension spring type
			Front suspension on helical springs
			Rear axle and suspension
			Rear suspension spring type
			The rear suspension on helical springs
				Service shock absorbers
				Removing and installing coil spring rear suspension
				Removal and installation of the transverse jet bar
				Removal and installation of longitudinal jet bars suspension
				Removal and installation of the stabilizer of transverse stability
				Removal and installation of assemblage of the mechanism off the rear stabilizer lateral stability
			Steering
		Body
		Onboard electric

printable version

Removal and installation of the stabilizer of transverse stability

Removing

PERFORMANCE ORDER

Poddomkratte back of the car and establish it on props, the institution under the rear axle housing.
Give nuts rack rod to the brackets of the chassis and remove the washers and rubber bushings (see. Accompanying illustration).

1 - nut
2 - Washer
3 - grommet
4 - Front
5 - the stabilizer bar
6 - rubber cushion
7 - Bolts
8 - Bracket

On models equipped with the mechanism off the rear stabilizer lateral stability Front right is part of the mechanism off. Procedures for removing and installing the assembly off the anti-roll stability are described in the next section (steering).

Give nuts of ball joint rack stabilizer lateral stability and remove the rack from the car.
Give bolts of support brackets rod stabilizer lateral stability to the rear axle housing. Remove the bracket from the vehicle.
Remove the anti-roll bar stability from under the car.

Setting

Installation is in the reverse order.

PERFORMANCE ORDER

Check the condition and track correctness of planting rubber pads in the brackets. Tighten the mounting bolts to 25 ÷ 32 Nm. When properly tightened bolts applying the paint marks on the stabilizer bar transverse stability should act equally on both sides.
Check the condition of the rubber bushings and ball joints rack stabilizer lateral stability, track correctness of landing components. Tighten the nuts of ball joint with a force of 25 ÷ 32 Nm.

« previos page
Removal and installation of longitudinal jet bars suspension

next page »
Removal and installation of assemblage of the mechanism off the rear stabilizer lateral stability