REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Primera (from 1990 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Primera
		Introduction
		Routine maintenance and servicing
		Engine
		Cooling and heating
		The power supply system and exhaust
		Electrical system motor
		Manual transmission, differential and the main transfer
		Automatic Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
			Front suspension
			Rear suspension
			Steering without the hydraulic booster
			Power steering (servo)
				general information
				Removal and installation of the servo
				Substitution cuffs steering
		Body
		Onboard electric
		Applications

Substitution cuffs steering

Replacing the cuff can be performed on the established mechanism.

PERFORMANCE ORDER

Lift the front of the car and unscrew the wheel.
Disconnect the ball joint tie rod from the steering arms.
Loosen the locknut next to the tie rod and unscrew the tip, thus counting the number of turns to completely remove the tip.
Loosen the clamps on the inside of the tie rod and a small clip on the outer side and remove the cuff.
Put the new seal and secure inside.
Screw the tie rod to pull on the same number of turns as when removed.
Connect the tie rod to the steering arm and tighten the castellated nut with a force of 37 - 46 N ??? m. Insert a new cotter pin.
After installation, check and, if necessary, adjust the toe.

next page »
Body