Controls

Location of controls and instruments shown in Fig. 1.3. Next will be considered the main ones.

LED Anti-lock brake system (4) lights up when the ignition is switched on (preheating devices and diesel engines) and goes out after starting the engine.

Operation of the indicator while driving indicates a fault in ABS. Despite the fact that this performance braking system is stored as soon as possible, refer to a qualified specialist.

Control of outdoor lighting and fog lights made using rotary switch (6). Parking lights come on when the switch is in a vertical position. When it engages in a second position Dipped or main beam headlights (depending on the position of the left column stalk 28).

For vehicles not equipped with front fog lamps, for the inclusion of additional rear fog lamp when the near or far light pull switch (6) to the first fixed position. If the vehicle is equipped with front fog lamps, while the dimensional illumination, as well as near or far light, while pulling the handle 6a in the first fixed position includes front fog lamps, and when you pull the handle 6a to the second position - the rear fog lights.

Regulator of lighting equipment and grip-leveling (7), you can adjust the brightness of the lighting instrument panel and adjust the angle of the light beam headlights depending on vehicle load. Regulator corrector has four fixed positions (as it can be installed in the intermediate position):

"-" - A car with a driver and passenger in the unloaded luggage;

"1" - a car with a driver and four passengers in the luggage unloaded;

"2" - a car with a driver and four passengers when fully loaded luggage and towing a light trailer;

"3" - a car with a driver when fully loaded luggage when towing a trailer the maximum authorized mass.

Lever for adjusting the steering column (9), located to the left of the steering column, is used to adjust the position of the steering wheel. To do this, press it down, install the steering wheel to the desired position and fix this position by lifting the lever all the way up.

Ignition switch (12) (for vehicles equipped with a diesel engine - the ignition switch, instruments and starter) has three positions:

- "turned off". When the key is removed included anti-theft device (remove the key from the ignition and turn the steering wheel until it clicks into the lock of a steering shaft; to unlock the anti-theft device, insert the key into the lock and turn it, shaking steering wheel from side to side);

- "Ignition" or "trigger devices and display";

- "starter".

If the engine does not start, return the key to "off", and only then try starting the engine (see. Sect. 1.7).

Front seat heating switch (13) (if heating is provided equipment) allows the engine running to warm cushions and backrests of the front seats. To turn off the heater, turn the knob all the way down.

Left multifunction steering column switch (Fig. 1.4) is used to switch between Main / dipped beam headlights, turn indicators and control cruise control.

When you press the lever to pull or push comes dipped or main beam. For short signaling high beam, briefly pull the lever towards you and release. By moving the lever up signs included a right turn, down - left. With the ignition off, moving the lever up included parking parking lights starboard side, down - left.

Cruise control maintains the set speed without affecting the accelerator pedal.

For short-term increase in speed (eg when overtaking), press the accelerator pedal: once you release it, the controller will automatically restore the already predetermined speed. You can also increase the speed, press and hold the button (1): movement speed will gradually increase, and after you release the key memory controller save.

Keep in mind that on cars with automatic transmission speed control can be used only if the provisions of ?�D?�, ?�1?� and ?�2?�. In case the selector switch to any other position, the controller automatically switches off. It is not recommended to use speed control when driving in dense traffic on roads with poor coverage, requiring frequent changes of tempo movement. On cars with a manual gearbox with the cruise control to prevent a sharp increase in engine speed, set the lever to the neutral position only after the clutch.

Right-hand stalk switch (26) (see. Fig. 1.3) is used to control the wiper and windshield washer. It has the following fixed positions:

- Starting position: all wiper and washer off;

- The first fixed position while moving up: normal speed of the windscreen wiper; when the lever until it locks in the first position the wipers are switched on for one turn;

- The second fixed position while moving up: the maximum speed of the windscreen wiper;

- Fixed position moving down: intermittent windshield wiper.

Pull and hold the lever (26) of any situation for yourself, you turn on the windscreen washer (in the rest position this will also include a few moves the wiper).

Pushing the lever away from you from any position includes a washer and rear window wiper.

Control Keys rear door windows (1) are located in the central part of the dashboard on the cigarette lighter.

Exterior mirrors (models with electric mirrors) are controlled by buttons. Select the appropriate mirror, and pressing the edges of the handle to adjust its position. If, for any reason, the mirror is not adjustable, its position can be set manually and carefully pressing on the edge of the mirror glass.