Repair of the rusted holes and holes

Repair of the rusted holes and holes is performed using above-mentioned abrasive or wire nozzle clamped in the chuck of an electric.

Remove all traces of paint from the damaged area and the area width of about 3 cm around it. In the absence of the possibility of using an electric work can be done just as effectively by hand with sandpaper.

After complete removal of the paint can assess the extent of damage to metal corrosion and determine whether it makes sense to start to repair or replace will be wiser panel entirely (if at all possible). It is often much faster and even more economical to install the new panel than to repair the extensive damage to the body.

Remove the damaged panel, all the elements of decoration of the body, except for those that can serve as a guide to re-create the original shape of the deformed sections (such as the lining of the block range, and so on. N.). Using tin snips or a hacksaw blade, remove any loose loose, loose and hopelessly corroded pieces of metal, and then fold the edges of the hole with a hammer inside to form a recess for containing a putty material.

Use the wire brush to remove the damaged metal powder rust. If you have access to the underside of the damaged area, treat it with a corrosion inhibitor.

Before the start of spackling hole must be plugged. This can be done by riveting or bolting to the damaged section on the back of his hand a piece of tin or blocking the hole with wire mesh.

After blocking the hole damaged area can be plastered and painted.