 printable version
Removal and installation of bearings / rear wheel hub
Elements of fastening of the bearing / hub of the rear wheel on the front-wheel drive
1 - self-locking bolt, 35 Nm
2 - rear brake caliper,
3 - bolts, 60 Nm
4 - the brake disk,
5 - bolts, 60 Nm | 6 - the bearing / hub of the rear wheel,
7 - tampovanny housing
8 - rear beam,
9 - the gauge of rotation of the rear wheel,
10 - lock the rear wheel rotation sensor |
A warning  When installing the bolt 1 is necessary to use a new bolt.
Bearing / hub of the rear wheel 6 form a single unit. In this case, does not require adjustment of the rear wheel bearing.
Withdrawal
| PERFORMANCE ORDER |  | 1. Remove the two screws on the brake caliper, while using a thin wrench, hold the guide pin from turning. | | 2. Remove the brake pads. | | 3. Remove the brake disc. |  | 4. Through the hole in the hub, remove the five bolts of the bearing / hub of the rear wheel. | | 5. Remove the bearing / hub of the rear wheel. |
|
Setting
| PERFORMANCE ORDER | | 1. Install the bearing / hub of the rear wheel and screw bolts, having tightened their moment of 60 Nm. | | 2. Install the brake disc. | | 3. Install the brake pads. | | 4. Install the brake caliper and secure it with the new self-locking bolts, with a thin wrench hold the guide pin from turning. |
|
|
