 printable version
Raising the car
Reference place under the jack on cars sedan and wagon
Set the jack to raise the car
A warning  If you need to carry out work under the vehicle, for insurance is necessary to use the stand. Support for only one car jack is not sufficient.
Do not start the engine lifted the car - it's dangerous.
To raise the vehicle must use a jack mounted under the bearing seat of the car body, which are located about 17 cm from the respective wheel arch, see. Fig. Supporting space under the jack on cars sedan and wagon and rice. Set the jack to lift the car.
A warning If the jack is not installed under the seat support body may damage the car body. In addition, there is a risk of injury.
Set the jack under the car. Lapa jack should be tightly cover the vertical edge of the spar to the jack when lifting a vehicle can not slip. At the same time should be to align the position of the jack and the jack to lift the leg until it is firmly not lie down to a vertical edge.
A warning When installing the jack on soft ground may drop the car off the jack. Therefore it is necessary to put the jack on solid ground. If necessary, use a stable and relatively large footprint.
For hanging car must use a lift. To avoid damage to the bottom of the car, be sure to use the appropriate lining of rubberized material.
A warning The car is in any case should not be lifted under the oil pan under the gearbox at the rear or the front axle, or may cause serious damage to components and assemblies.
Before entering the lift, make sure that there is sufficient distance between the low-lying points of the car and lift the elements. Position foot lift at the front of the vehicle | At the front of the car lift leg set for the amplifier underbody. |
Position foot lift at the back of the car
| In the rear leg lift set by the vertical gain spars in the area to mark the installation of the jack (1). |
The car should not be lifted at the front spar vertical reinforcing ribs.
| 
