printable version
Adjust selector lever cable
Selector lever cable adjust if necessary selector lever cable is disconnected from the gearbox. Either engine and (or) transmission have been removed / installed. If you shoot / sets itself cable or the gearshift or It was changed position of the motor / gearbox, for example, to eliminate stress or misalignment.
Adjustment Set the selector lever to position "P". 2 Remove the bolt rope 1.
Gently shake the handle of the selector lever back and forth, in any case, he is not bringing the lever from position ?�P?� (Fig. 3.84). This cable takes the best position in its shell. Set the lever / shaft shift control 3 on the gearbox into position "P" (press the lever back).
NOTE To check whether the gearboxes including the situation ?�P?� (Transmission disabled), you need to lift the vehicle. Both front wheels should not rotate in the same direction. |
2 Tighten the screw to 15 N ?� m. Emergency release selector lever Do not remove the lever handle. Remove the cover locks the selector lever and twisting cover, lift the frame to handle. Press the service brake pedal or apply the parking brake.
Push the yellow plastic piece on the right side, to press it to the left (Fig. 3.85). After that, the lever can be deduced from the position "P".
|