add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Transmission
Chassis
Wheels and tires
Front suspension
Rear suspension
Repair of suspension of the rear wheels (front wheel drive)
Repair subframe
Replace the level sensor in the car body
Removal and installation of the upper arm
Removal and installation of the lower control arm
Removal and installation of lateral traction
Removing and installing the trailing arm with mounting bracket
Repair trailing arm
Removing and installing coil spring
Tables
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of the upper arm



Withdrawal
Remove the wheel.
Remove the coil spring.
Hang out the wire speed sensor on the upper wishbone.

Ektsentrikovy bolt the subframe
Fig. 4.69. Ektsentrikovy bolt the subframe


Note, for example, felt pen, the position of the eccentric relative to the subframe bolts (Fig. 4.69).
Remove the bolt.
Remove the upper wishbone.

Setting
Insert the upper wishbone in the car and tighten the screws by hand.
Tighten the control arm is only performed when it reached the size of ?�a?�.
Screw the upper wishbone on the subframe and tighten the new nut.
Note the labeling provisions of the eccentric bolt with respect to the subframe.
Tighten the bolt 1 upper arm.

NOTE
Make sure that between the bolt and the housing of the wheel bearing washer was installed.

Secure the speed sensor on the upper wishbone.
Install the coil spring.
Install and tighten the wheel.
Adjust the wheel alignment.




« previos page
Replace the level sensor in the car body
next page »
Removal and installation of the lower control arm

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.