REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
			Overview
			General verification procedure
			Brake system repairs
				Removing and installing brake pads
				Removing and installing control unit electromechanical parking brake
				Removal and installation of the parking brake
				Disconnecting the brake pedal from the brake booster
				Connecting the brake pedal to the brake booster
				Removal and installation of the piston to the brake caliper FN 3
				Removing and installing piston brake caliper
				Removing and installing brake light switch F
				Removal and installation of the main brake cylinder
				Removing and installing brake booster
				Repair the brake pipe
				General information on the anti-lock system
				Removing and installing speed sensor on the front axle
				Removing and installing speed sensor on the rear axle
				Removing and installing speed sensor on the rear axle
				Removal and installation of the gauge of low pressure in the brake booster
			Tables
		Onboard electric
		Body
		diagrams

printable version

Removing and installing speed sensor on the rear axle

Components of ABS on the rear axle (AWD)

Fig. 6.64. Components of ABS on the rear axle (all wheel drive): 1 - speed sensor ABS; 2 - a bolt with hexagon socket, 8 Nm; 3 - pin and wheel end

Withdrawal

Raise the vehicle.

Fig. 6.65. Connector cable speed sensor and speed sensor

Disconnect connector 1 cable speed sensor and speed sensor (Fig. 6.65).

Remove the bolt 2 from the wheel bearing housing.

Remove ABS speed sensor from wheel bearing housing.

Setting

Before installing, clean the hole and put on a little sensor refractory grease G 052 112 A3.

Insert the speed sensor into the hole wheel bearing housing and tighten bolt to 8 Nm.

Connect the speed sensor to the sensor cable.

« previos page
Removing and installing speed sensor on the rear axle

next page »
Removal and installation of the gauge of low pressure in the brake booster