REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
			Lubrication system
			Cooling system
				Removal and installation of elements of the cooling system
				Draining coolant Bay
				Removing and installing radiator
				Removal and installation of the water pump
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
			Lubrication system
			System ohlazhdeiya
			Fuel system
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Removal and installation of elements of the cooling system

Fig. 2.61. The cooling system installed on the body 1 - coolant hose, the top; 2 - O-ring; 3 - radiator; 4 - a cover; 5 - plug; 6 - a bolt 5 Nm; 7 - a broad tank; 8 - an arm; 9 - a bolt 5 Nm; 10 - Bearing; 11 - bolt 10 Nm; 12 - an arm of the fans; 13 - a bolt 5 Nm; 14 - radiator fan; 15 - the plug; 16 - radiator fan; 17 - the coolant hose, the bottom; 18 - mounting bracket; 19 - coolant temperature at the outlet of the radiator; 20 - O-ring; 21 - O-ring

ATTENTION

When all installation work, in particular in the engine compartment, because of the tight layout, consider the following

Lines of all types (e.g. fuel, hydraulic absorber, activated carbon, cooling systems, coolant, brake lines, vacuum tubes), and also necessary to lay electric wires as they were originally laid.

Provide sufficient space to all moving or hot components to avoid damage to any kind of lines.

NOTE

When the engine is warm the cooling system is under pressure. If necessary, the repair work is necessary to relieve the pressure.

Hose connections are secured with spring clips. When repairing only use spring clamps.

For the installation of spring clamps recommended use pliers for spring clips.

When set to pave the coolant hoses, pulling on them. Make sure that they do not touch other components (observe markings on the pipe and radiator hose).

« previos page
Cooling system

next page »
Draining coolant Bay