printable version
Removal and installation of the upper arm
Withdrawal Remove the wheel. Remove the coil spring. Hang out the wire speed sensor on the upper wishbone.
Note, for example, felt pen, the position of the eccentric relative to the subframe bolts (Fig. 4.69). Remove the bolt. Remove the upper wishbone.
Setting Insert the upper wishbone in the car and tighten the screws by hand. Tighten the control arm is only performed when it reached the size of ?�a?�. Screw the upper wishbone on the subframe and tighten the new nut. Note the labeling provisions of the eccentric bolt with respect to the subframe. Tighten the bolt 1 upper arm.
NOTE Make sure that between the bolt and the housing of the wheel bearing washer was installed. |
Secure the speed sensor on the upper wishbone. Install the coil spring. Install and tighten the wheel. Adjust the wheel alignment.
|