add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Preliminary checks on the car
The mechanical part (petrol engines 3,2L)
The mechanical part (petrol engines 4,2L)
Checking the valve guides
Replacing the oil seal on the side of the crankshaft vibration damper
Removing and installing drive plate
Removal and installation of the flange on the side of the drive plate
Removal, installation and tension of the toothed timing belt
Checking axial clearance of camshafts
Replacing the camshaft seals
Replacement seals Hall sensors
Removing and installing the camshaft and controls the valve timing
The mechanical part (diesel engines 5,0L)
Removing and installing subframe
Pressurization system (diesel engines)
Cooling system (petrol engines)
The cooling system (diesel engines)
Lubrication (petrol engines)
Lubrication system (diesel engines)
Injection System (petrol engines)
Fuel injection system (diesel engines)
Exhaust
FUEL (beninovye engines)
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing drive plate



Withdrawal
Remove the engine.
Disconnect the engine and gearbox.

Installing the engine to TDC
Fig. 2.99. Installing the engine to TDC


Bring engine to TDC. To this end, slots A and B must be on the same level (Fig. 2.99).

NOTE
To turn the engine follows the central bolt of crankshaft.
To turn the engine is permitted only in a clockwise direction.

Screw plug
Fig. 2.100. Screw plug


Unscrew the cap (Fig. 2.100).

NOTE
For a threaded plug in the crankshaft, is opening TDC (tangible hand).


Fixing bolt
Fig. 2.101. Fixing bolt


Screw the locking bolt 3242 in the crankshaft (Fig. 2.101).
Loosen the screws crosswise drive plate and unscrew them.
Remove drive plate with shim washer and compensation.

Setting
Install in reverse order, with the following should be considered:
Put shims 1 (thickness: 3.4 mm) to the crank pin of the crankshaft.

To install a drive plate
Fig. 2.102. To install a drive plate


Then install the drive plate with the washer 2 (thickness: 1.5 mm) (Fig. 2.102).
Insert the new retaining bolts and tighten them by hand.
Tighten bolts with a torque of 30 Nm + 1/4 turn (90 ?�) (dotyazhka can be performed in several stages).
Remove the locking bolt 3242.
Tighten the screw plug with a new seal. Torque: 35 Nm




« previos page
Replacing the oil seal on the side of the crankshaft vibration damper
next page »
Removal and installation of the flange on the side of the drive plate

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.