printable version
Replacement seals Hall sensors
The order of work (left cylinder head) Disconnect the connectors for ignition coils and fuel injectors and set aside the wire. Disconnect the plug from the Hall sensor. Remove the sensor together with a plug and the plug.
The right cylinder head Remove the right cover of the toothed belt. Disconnect the plug from the Hall sensor. Loosen the screws 1 on the Hall sensor.
| Fig. 2.122. Sensor bolt and back cover of a gear belt
|
Pull the back cover of a gear belt slightly forward and remove the case of the Hall sensor with plug and plug.
Tighten finger 2085/1, as shown in Figure 2.123.
Remove the inner part of oil seal extractor 2085 a few turns of the outer part and lock the knurled screw (Fig. 2.124). Lubricate threaded head of a stripper with engine oil, and attach strongly pressing it, screw as far as possible in the packing. Loosen knurled screw and scroll through the inside of the stripper finger against 2085/1 until the gland will not be removed. Clamp the puller gland for flat edges in a vise. Tongs remove the gland.
Finally, press in new shaft seal mandrel 3241/1 and bolt 3241/3 flush (Fig. 2.125). Further installation is performed in reverse order.
|