printable version
Checking and topping up the level of oil ATF
NOTE If the ATF circuit was opened, it must first be pumped air from the ATF. Only after that check the level of oil ATF and fill as necessary. |
NOTE With the old system for the Gulf ATF VAG 1924, reduce the width of the hook 20 mm. Only then can insert the hook into the hole for level ATF. Remove burrs and clean the hook after cutting. |
Short description ATF level is checked when the engine is running at a certain temperature and oil ATF. ATF temperature is requested tester - VAS 5051B. Upon reaching the desired temperature to control the twist-off cap of level ATF in the oil sump. With a lack of ATF in the gearbox, it does not follow from a control aperture - you must add ATF. With an excess of ATF in the gearbox drain surplus ATF. At the appropriate level ATF drains a little oil from the ATF inspection hole. Screw the cap after checking ATF with new oil seal and tighten.
ATTENTION Wrong ATF level adversely affects the transmission. |
The temperature at which checks the level of ATF, shown below.
|