add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Overview
Generator and starter
Device combination
Removal and installation of the instrument cluster
Pin connectors dash
Front wiper
Headlights
Tables
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of the instrument cluster



Withdrawal

Removing the panels
Fig. 7.69. Removing the panels


Pry and remove the panels 1 and 2 with a wedge T10039 / 1 of clamps (Fig. 7.69).

NOTE
To remove the steering wheel is not required. However, for clarity, the following figures the wheel not shown.
Steering column with electrical or mechanical adjustment set to the lowest position and pull it out until it stops.
Turn the ignition and all electrical consumers and remove ignition key.



Removing the wall panel
Fig. 7.70. Removing the wall panel


Remove the screws 1 the top wall panel of the steering column 2 and remove the cover (Fig. 7.70).
Remove the hood of the instrument cluster.

Holder screw visor dash
Fig. 7.71. Holder screw visor dash


1 Remove the screws of the hood of the instrument cluster 2 (Fig. 7.71).

The top bolts
Fig. 7.72. The top bolts


Unscrew bolts 1 (fig. 7.72).
Remove the holder of the instrument cluster hood, pulling it up.

Connectors
Fig. 7.73. Connectors


Remove the instrument cluster and unplug connectors 1 on the back of the instrument cluster (Fig. 7.73).

Setting
Install in reverse order, with the following should be considered.
Install the instrument cluster into the slot on the front panel, and connect the connectors.
Attach the hood of the instrument cluster.
After installation, check the operation of the functions of the instrument cluster.

Description of the rear side of the instrument cluster

The back side of the instrument cluster
Fig. 7.74. The back side of the instrument cluster: 1 - socket, 32-pin; 2 - socket, 32-pin




NOTE
Do not disassemble the instrument cluster. If required, the instrument cluster is replaced in gathering.




« previos page
Device combination
next page »
Pin connectors dash

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.