printable version
General information
Transmission When you install the transfer case watch correct position fitting hub between transfer case and transmission. When installing the bearing supports and associated parts, clean the adjacent surfaces. Remove the lubrication of the contact surfaces and degrease them. When replacing the transfer case thread the machine on the bottom edge of the filler hole.
Retaining rings Replace the retaining rings. Retaining rings twist. Retaining rings must rest against the seating surface at the bottom of the groove.
Bolts, nuts Unscrew and tighten opposing bolts or nuts of covers and housings crosswise. Self-locking nuts and bolts replace always. On all threaded connections, if necessary, lubricate the contact surface and the bolts / screws and nuts only after installation. All threaded holes into which self-locking bolts are screwed / screws must be cleaned from the remnants of a threaded tap varnish. Otherwise, the next dismantling of the thread can be disrupted.
Bearings Needle bearings push the mandrel with the side where the marking (metal thickness).
|