REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Audi
	A6
		General Information
		Operation of the vehicle
		Maintenance
		Engines
		Ignition, fuel injection and exhaust of gasoline engines
		The power supply system, and preheating the exhaust gases of diesel engines
		Lubrication System
		Cooling system
		Coupling
		Transmission
		The front wheel drive shafts
		Design features four-wheel drive transmission
		Suspension
		Wheels and tires
		Steering
		Brakes
			Overview
			Anti-lock brakes (ABS)
			Electronic Stability Program (ESP)
			General recommendations for the maintenance and repair of the anti-lock braking systems and electronic stability
			Replacing brake pads front brake FN-3
			Replacing brake pads front brake HP-2
			Replacing the rear brake pads
				Withdrawal
				Setting
			Repair of forward support FN-3
			Repair of forward support HP-2
			Repair of a back support
			Brake disk
			The parking brake cable front-wheel drive
			Brake Cable-wheel drive vehicles
			Adjusting the parking brake
			Bleeding the hydraulic brake drive
			Brake fluid (every 2 years)
		Body
		Heating and air conditioning
		Electrical
		Electric schemes

printable version

Withdrawal

Lift the rear of the car and fix on supports.

Always replace all pads on one axle of a vehicle, even if worn only one of them.

Fig. 15.14. Unscrewing bolts slide

Remove the caliper mounting bolts holding the other key to turning the guide pin (Fig. 15.14). Remove the caliper and a soft wire tie him to the rear suspension. Caliper should not hang on the brake hose. Brake hose should not stretch or be overwound.

If the old block will be reinstalled, mark them.

Remove the brake pads from the caliper.

Clean the saddle from dust and dirt.

« previos page
Replacing the rear brake pads

next page »
Setting