 printable version
The front panel with a transverse auxiliary elements
Withdrawal Before disconnecting the battery find out whether you have a code switch on the radio. Switch off the ignition and disconnect a wire of "weight" from the storage battery. Remove the front bumper.
| Fig. 16.1. Location bolts of air nozzles (1 and 2)
|
Remove the bolts and remove the air tubes 1 and 2 (Fig. 16.1). Disconnect the electrical connectors from the front transverse panel. Remove the bolts of the heat exchanger oil the power steering and take him aside, without disconnecting from it pipelines. Set under the radiator drain pan coolant.
| Fig. 16.2. Location cork drain coolant from the radiator
|
Rotate counter-clockwise, remove the drain plug from the radiator coolant drain shown in Fig. 16.2 arrow. When installing the plug you want to use a new sealing koltso.Oslabte bolts ribbed belt tensioner and remove the air conditioning compressor belt from pulleys. Remove the air conditioning compressor mounting bolts and soft wire tie it to the body.
A WARNING The cooling circuit air-conditioning system is not open. |
Remove the bolts of the heat exchanger oil the power steering and take him aside, without disconnecting from it pipelines.
| Fig. 16.3. Location couplings oil pipeline automatic transmission
|
On vehicles with automatic transmission, set the pan to collect the oil, remove the couplings and disunite oil pipeline transmission (Fig. 16.3).
| Fig. 16.4. Location clamp fixing the air hose from the cooler air nadduvaemogo
|
On cars with turbocharged, loosen the clamp and remove the air hose from the cooler air nadduvaemogo (Fig. 16.4). Remove the right and left sides of the bonnet seal mounted between the wings and the front transverse panel.
| Fig. 16.5. The front panel with lateral support elements: 1 - the front cross bar; 2 - a bolt of Torx, 10 Nm; 3 - combined bolt, 50 Nm; 4 - combined bolt, 50 Nm; 5 - combined bolt, 50 Nm; 3396 - a special tool
|
Ask the assistant to support the front transverse panel, unscrew the screws 3, 4 and 5, and remove the panel from the car.
Setting Installation is performed in reverse order of removal. Connect the oil pipes of an automatic transmission. Fill the cooling system with coolant. Check the connection of the electrical connectors. Connect a wire of "weight" to the battery. Turn on the radio and enter the code. Lift up the power window glass until it stops. Then click on all window switches again for at least 1, in the closed position of the control unit to activate windows. Set the clock. Adjust headlights.
Placing in the service position Switch off the ignition and disconnect a wire of "weight" from the storage battery. Unscrew the front of the bottom mudguard of a motor compartment. Remove the bolts and remove the air tubes 1 and 2 (see. Fig. 16.1). On the right side of the car, remove the bolt 5 (see. Fig. 16.5), and instead screw the special tool 3369.
| Fig. 16.6. Using a special tool 3369 to install the front transverse panel in service position
|
On the right side of the vehicle Screw the special tool 3369 into the threaded hole (Fig. 16.6). Unscrew the bolts 3 and 4 (see. Fig. 16.5) and move forward the front transverse plate so that the hole in the rear panel is aligned with the front opening in the flange of the wing.
| Fig. 16.7. Securing bolt (2) of the front transverse panel (1) in the service position
|
Bolted the front transverse panel in service position (Fig. 16.7).
| 
