add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Design Features
Compression check in cylinders
Removal and installation of mudguards of the engine
Mount Replacement power unit
Installation of the piston of the first cylinder to TDC of the compression stroke
Removal, installation and Troubleshooting flywheel
Replacement parts Seal Engine
Cylinder Head
Removing, Troubleshooting and installation of a camshaft
Replace the lash clearance in the valve mechanism
Possible faults in the mechanism of clearance of hydraulic actuator valves, their causes and remedies
Disassembly, repair and assembly of cylinder head
Lapping Valves
Removing and installing engine
Engine repair
Lubrication system
Cooling system
Exhaust
The power supply system of the engine
The system EVAP
Exhaust gas recirculation
Transmission
Chassis
A steering
The brake system
Electrical
Body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Replace the lash clearance in the valve mechanism



Tappet clearance in the valve mechanism are self-adjusting support push levers that transmit the force from the camshaft to the valves, and the function of eliminating gaps in the drive.
The work is based on the principle of hydraulic incompressible engine oil, continually filling with the engine hydraulic lifters inner cavity and moves it to the plunger when a gap in the actuator valve, ensuring constant contact with the valve actuator lever cam camshaft without clearance. This eliminates the need to adjust the valves for maintenance.
Almost all the fault of hydraulic diagnosed by the characteristic noise issued by the timing at various engine operating modes.
For replacement of hydraulic cylinder head can not be removed from the engine. It is enough to remove the camshaft. However head gasket then carefully replaced with a new recommended, since the camshaft and a cylinder head attached to the block by the same bolts and bolt retightening the cylinder head gasket may not ensure a good seal.
You will need: all the tools necessary to remove the camshaft (see. "Removing, Troubleshooting and installation of a camshaft").
NOTE
Work carry out 15-30 minutes after stopping the engine to reduce the oil pressure in the hydraulic lifters.

1. To replace the lash remove the camshaft (see. "Removing, Troubleshooting and installation of a camshaft").
NOTE
In contrast to the work to remove the camshaft in this case need not be removed from the body of the camshaft ignition coil and its holder.

2. Remove the pressure lever and mounted on the valve stem biscuit.

NOTE
If there is no need to replace, cracker can not shoot.

3. Remove the socket head of the block tappet.

NOTE
Tappet head is installed in the socket with a slight interference fit and can be easily removed without the use of any tool.

4. Grease a new tappet and nest in the cylinder head with engine oil and install the tappet into the slot.
5. Similarly, replace the rest of the lifters.
6. Install the cylinder head and the details of the timing in the reverse order of removal.
NOTE
After replacing the lash when you first start the engine for a short time can be noisy until the tappet is not to pump over.




« previos page
Removing, Troubleshooting and installation of a camshaft
next page »
Possible faults in the mechanism of clearance of hydraulic actuator valves, their causes and remedies

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.