REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Chevrolet
	Lanos
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
			General provisions
			Daily maintenance (EO)
			The first maintenance (1)
				Check and adjust belt drive alternator and power steering pump
				Check and adjust belt drives the air conditioning compressor
				Check the timing belt
				Replacing the engine oil and oil filter
				Clean the crankcase ventilation system
				Check hoses and connections of the cooling system
				Check exhaust system
				Leak test fuel
				Replacement of the fuel filter
				Replacing the air filter element
				Check and adjustment of drive clutch
				Checking and topping up the oil in the gearbox
				Check of protective covers of drives the front wheels
				Checking the technical condition of the front suspension parts on the car
				Check of a technical condition of details of the rear suspension on the car
				Check and adjust wheel alignment
				Inspection and steering on the car
				Checking freewheel (backlash) of the steering wheel
				Leak test hydraulic brakes
				Check the wear of brake pads, discs and drums
				Check the operation of the brake servo
				Check braking efficiency
				Checking the parking brake
				Service Battery
				Replacement and service of spark plugs
				Check and adjust headlights
				Grease fittings Body
				Cleaning the drainage holes
			The second maintenance (TO-2)
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
		Wheels and tires
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Tips novice mechanic
		Applications
		Diagrams

printable version

Checking and topping up the oil in the gearbox

You will need: the key "13", a syringe.

NOTES

The gearbox add oil BO 400075 SAE 80W.

Oil change is required (only top-up) during the entire life of the transmission. However, it is recommended to replace the factory filled oil to the gear oil SAE 75W-90, if the vehicle is operated for a long time at ambient temperatures below -30 ?� C.


1. Remove the oil level plug gearbox, located on the transmission case near the inner joint of the right wheel drive. The oil level should be at the edge of the inspection hole or below (you can reach the surface of the finger oils).	2. If the oil level is greatly reduced (you can not control with your finger) to remove the protective cap from the top-up plug for the oil filling holes located on top of the intermediate gearbox casing.


3. Loosen the plug ...	4. ... and remove it.

NOTE

Stopper oil fill at the same time serves as a breather, so check the purity of holes in it.


5. Pour the oil syringe into the hole in the intermediate casing ...	6. ... until it emerges from the inspection hole. Screw the oil level plug.

HELPFUL ADVICE

The tube is installed a magnet to collect metallic wear debris, clean it before installing the tube.

7. Screw cap oil fill and put on her cap.

A WARNING

Operating a vehicle without a protective cap cork banned! In its absence, the transmission will get the dirt road.

« previos page
Check and adjustment of drive clutch

next page »
Check of protective covers of drives the front wheels