REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
			Manual Transmission
			Automatic transmission
				Technical data
				The control lamp fault (MIL)
				Diagnostic trouble codes
				Read fault codes
				Check the transmission fluid pressure
				Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
				Check the fluid level in automatic transmission
				Check the operation of the selector lever
				Adjustment of the switch indicate the position of the selector lever
				Adjusting the servo compulsory inclusion downshift
				Adjust the line pressure
				Replacement of an oil sealing ring of a power shaft
				Replacement of a cable drive speedometer
				Removing and installing transmission
				Repair Transmission
				Lever
				Control Cable
				Repair of the selector lever
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Adjust the line pressure

PERFORMANCE ORDER

1. Drain the transmission fluid of the automatic transmission.
2. Remove the oil pan.
3. Remove the oil filter.
	4. Remove the transmission fluid temperature sensor.
	5. Press the latch and pull the O-ring of the solenoid valve.
	6. Remove the valve assembly, with the caution that it does not fall.
	7. Rotate the adjustment screw of the distributor so that the pressure in the line has reached the desired value. Rotation of the screws in a clockwise direction decreases the pressure on the other hand, counterclockwise - to increase. Nominal pressure: 860-900 kPa The change in pressure when turning the screws on the turnover of 1: 38 kPa
8. Make sure that the O-ring is mounted on top of the valve body in the location shown in the figure.
9. Replace the O-ring of the solenoid valve.
	10. Install the valve body in the housing and insert the connector of the solenoid valve in the crankcase. Make sure the notched part of the connector is installed as shown in Fig.
11. Tighten the housing torque 10-12 N ??? m.
12. Install the oil filter.
13. Install the new oil pan gasket and oil pan.
14. Pour the required amount of transmission fluid in the automatic transmission.
15. Check the line pressure.