REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
			Manual Transmission
			Automatic transmission
				Technical data
				The control lamp fault (MIL)
				Diagnostic trouble codes
				Read fault codes
				Check the transmission fluid pressure
				Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
				Check the fluid level in automatic transmission
				Check the operation of the selector lever
				Adjustment of the switch indicate the position of the selector lever
				Adjusting the servo compulsory inclusion downshift
				Adjust the line pressure
				Replacement of an oil sealing ring of a power shaft
				Replacement of a cable drive speedometer
				Removing and installing transmission
				Repair Transmission
				Lever
				Control Cable
				Repair of the selector lever
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Lever

1 - wire transmission control;
2 - a nut;
3 - lock solenoid locks;
4 - wire and backlight control panel manual transmission;
5 - O / D switch;
6 - button;
7 - the handle;

8 - the control panel manual transmission;
9 - adjusting the cam lever;
10 - the selector lever;
11 - the switch of neutral position of the gearbox;
12 - an arm;
13 - connector end of the cable.

Withdrawal

PERFORMANCE ORDER

1. Remove the central console.
2. Unscrew the handle of the selector lever.
	3. Disconnect switch overdrive, remove the three pins of the connector and remove the handle from the lever.
4. Disconnect the control panel backlight transmission.
	5. Remove the transmission control.
	6. Remove the clamp fastening rods.
	7. Remove the clip from the selector lever.
	8. Remove the screws and washers securing the cable under the dashboard.
9. Remove the clamp fixing the cable from the gearbox.
	10. Remove the control cable transmission.

Check

PERFORMANCE ORDER

1. Check the function of the transmission control cable and damage.

2. Check the bushing for wear or damage.

3. Check spring for damage and loss of elasticity.

4. Check the conductivity switch overdrive. When activating overdrive pins 1 and 2 switches must be closed, and when deactivating must be closed terminals 1 and 3.

Setting

PERFORMANCE ORDER

	1. Grease the inside of the sleeve. Lubrication: SAE J310, NLGI ?��0
	2. Move the selector lever and the transmission range switch in position N and connect the control cable.
	3. When connecting the cable to move the transmission control cable bracket, the cable is not aligned with the gear lever.
	4. Install the washer and screw the bolt and nut of the cable.
	5. From the terminal, set the selector lever.
6. Connect the backlight indicator lever position selector switch connector O / D, parking switch connector and terminal mode of motion.
	7. Install the panel transmission.
	8. Apply grease in the location shown in the figure. Lubrication: SAE J310, NLGI ?��2
9. Set the selector lever to position N, and then turn the cam cover so that the gap between the plate and the cam assembly conform to the required value. Clearance: 15,2-15,9 mm
	A warning Make sure that the parties to the adjustment of the cam lever in the side buttons.
10. Turn the O / D on the handle of the lever, then insert the contacts into the connector switch.
11. Set the lever and secure it with two screws.
	12. Install the central console.

« previos page
Repair Transmission

next page »
Control Cable