REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
			Technical data
			Lower arm front suspension
			Replace the lower arm bushing
			Replacement of the plug (G) of the lower arm
			Front stabilizer
			Rear strut
			Replacing the rear trailing arm bushings Rear suspension
			Replacing the rear control arm bushing (A and B) of the rear suspension
			Rear anti-roll bar
			The corners of the front axle
			Adjustment of a convergence of back wheels
			Tyre wear
			Anti-skid chains
			Runout
			Tightening the wheel nuts
			Shift of wheels
			Check withdrawal and course instability of the car
			Caring for aluminum alloy wheels
			Troubleshooting
			Diagnosis tire wear
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Adjustment of a convergence of back wheels

The convergence of the rear wheels 3 ?� 2 mm

A warning

When adjusting the convergence of the rear wheels of the adjusting bolt on the lower wishbone (B) must be rotated by the same angle from both sides of the vehicle.
Eccentric screw must be rotated at an angle within 90 ?�.

Inside the car: positive convergence

Outside the vehicle: a negative toe

The scale is scaled on a scale of approximately 2.4 mm, which corresponds to the angle of rotation 14 '.

« previos page
The corners of the front axle

next page »
Tyre wear