|
|
 printable version
SOHC engine oil pump
1 - cork, 40-50 N ??? m;
2 - O-ring;
3 - plunger;
4 - bolt, 12-15 N ??? m;
5 - a forward sealing ring;
6 - The front cover;
7 - internal gear oil pump;
8 - External gear oil pump; | 9 - a cover of the oil pump;
10 - a lining;
11 - a lining;
12 - maslozabornaya tube;
13 - a bolt, 15-22 N ??? m;
14 - oil pan;
15 - Oil filter. |
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the timing belt. | | 2. Remove all screws on oil sump. | | 3. Remove the oil pan. | | 4. Remove the 2 bolts and remove oil strainer with oil receiving pipe. | | 5. Remove the front cover. | | 6. Remove the oil pump. | | 7. Remove the internal and external gear pump the oil out of the front cover, previously noting their relative position. | | 8. Remove the plug and remove the spring and plunger. |
|
Check
| PERFORMANCE ORDER | | 1. Check oil pan for cracks or damage and replace it if necessary. | | 2. Check the oil filter for cracks or damage and replace it if necessary. | | 3. Check the front cover for wear or damage in contact with the gear oil pump and replace it if necessary. | | 4. Check for worn or damaged gear teeth oil pump. |  | 5. The probe measure the gap between the gear and the oil pump jack in a cover. Maximum permissible backlash external gear of the oil pump: 0,12-0,18 mm |  | 6. The probe measure the gap between the teeth of the gear oil pump. Maximum permissible backlash between the teeth of the gear oil pump: 0.001-0.003 mm | | 7. The metal ruler and a feeler gauge, measure the side clearance of the oil pump gear. Maximum permissible backlash of rotors of the oil pump: 0.04-0.06 mm |  | |
|
Setting
Oil pump
| PERFORMANCE ORDER |  | 1. Install the outer and inner gear of the oil pump in the front cover, pre-aligning the marks made previously. | | 2. Install the oil pump cover and secure it with screws. After tightening the bolts, make sure that the gears are turned easily and smoothly. Torque: 8-12 N ??? m | 3. Install a safety valve, a spring and screw cap, having tightened its demanded moment. Before installation grease relief valve engine oil.
Torque: 40-50 N ??? m |
|
Front oil seal ring
| PERFORMANCE ORDER | | 1. Inspect the O-ring for wear or damage working edges and replace it if necessary. | | 2. Check the condition of the spring confining ring sealing lips of the sealing ring. |  | 3. Lubricate the outer surface of the new O-ring with engine oil. The special tool 09231-22100 or sleeve of appropriate diameter, set the O-ring on the crankshaft until it touches the front cover. |  | 4. The special tool 09231-22000 install the O-ring fully into the socket of the front cover. | | 5. Install the crankshaft pulley, timing belt and crankshaft pulley. | | 6. Replace the oil filter. | | 7. Remove any remnants of the old gasket mating surface of the oil pan and the engine block. |  | 8. Apply a continuous layer of the sealant 4 mm on an interfaced surface of the oil pan. Around the bolt holes sealant placed on the inner side. After applying the sealant must install pallet no more than 15 minutes. | 9. Install the oil pan to the engine block and tighten bolts.
Tightening torques: 6-8 N ??? m |
|
|
|
