REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Elantra
		Gasoline engines 1.6, 1.8 and 2.0 liters
		The diesel engine of 2.0 liters
		Greasing system
		Cooling
		Fuel system
		Control systems and emission control
		Ignition system
		The system of preliminary heating of the diesel engine
		Coupling
		Manual transmission
		Automatic Transmission
		Drive shafts, front and rear axles
		Suspension
		Steering
		Brakes
			Technical data
			Check the brake servo
			Check unilateral vacuum valve
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Brake pedal
			Vacuum brake booster
			The main brake cylinder
			Replacing the front brake pads
			Caliper front brake
			Rear disc brakes
			Rear drum brakes
			Replacing the working brake cylinder
			Pressure regulator
			Brake tubes and hoses
			Parking brake
			Anti-lock brakes (ABS)
			Hydraulic block HECU
			Wheel speed sensor
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Troubleshooting
		Body
		The air conditioning system
		Electrical equipment
		Electrical diagrams

printable version

Parking brake

Withdrawal

PERFORMANCE ORDER

Remove the rear console.

Remove the adjusting nut and remove the parking brake cable.

Remove the parking brake switch.
Remove the parking brake lever.
Remove the wheel.
Remove the brake drum.
Remove the brake pads.

Disconnect the parking brake cable from the lever on the brake pads.

Remove the clamp securing the parking brake cable sheath to a brake board.

Loosen the clamp on the parking brake cable and remove it from the vehicle.

Check

PERFORMANCE ORDER

Check the operation of the parking brake switch.
Check the parking brake lever ratchet for wear.
Check the parking brake cable for wear or damage.

Setting

PERFORMANCE ORDER

Check the markings on the left and right parking brake cable and install in its place.

Identification color:

Left: Red
Right side: Yellow

Move the parking brake lever on the brake pad all the way back and install spring.

Install the parking brake cable in the direction shown in the figure.

Lubricate the recommended grease the ratchet and pawl ratchet parking brake lever.
Recommended lubricant: SAE J310, NLGI ?��2.
After installation, adjust the compensator move the parking brake lever.

After positioning the compensator at a distance of 40 mm from the lever, pull the cables by hand and screw the adjusting nut in a position in which the parking brake lever stroke is equal to 8 clicks.

« previos page
Brake tubes and hoses

next page »
Anti-lock brakes (ABS)