add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Elantra
Home
 
Hyundai
Elantra
Gasoline engines 1.6, 1.8 and 2.0 liters
The diesel engine of 2.0 liters
Greasing system
Cooling
Fuel system
The fuel system of petrol engines
Technical data
Troubleshooting
Check idle speed
Checking the fuel pump
Replacement of the fuel filter
Replacing the overflow limiter (two-way valve)
Replacing fuel level sensor
Verification system of injection MFI
The control lamp fault (MIL)
Diagnostic trouble codes
Sensors
Fuel injectors
The modulator control the speed of the crankshaft of the engine idling (ISC)
Vehicle speed sensor (VSS)
The knock sensor (KS)
Ignition switch (ST) and the band switch (TR) in vehicles with automatic transmission
Ignition switch (ST) on vehicles with manual transmission
The engine control unit
Switch and switch the air conditioning system
The solenoid valve of clearing of the canister fuel vapor recovery (EVAP)
Main relay MFI
Ignition coil
Fuel pump
Acceleration sensor APS
Oil valve (OCV)
A fuel highway and injectors
Throttle knot
Fuel tank
The pedal and the accelerator cable
The fuel system of diesel engines
Control systems and emission control
Ignition system
The system of preliminary heating of the diesel engine
Coupling
Manual transmission
Automatic Transmission
Drive shafts, front and rear axles
Suspension
Steering
Brakes
Body
The air conditioning system
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

The modulator control the speed of the crankshaft of the engine idling (ISC)



The modulator control the speed of the crankshaft of the engine idling is provided with two coils, which are managed by individual driver stage engine control unit. Depending on the pulse supplied to them, balance the magnetic forces of the two coils results in different angles of rotation of the modulator.

The modulator is installed in the air passage that bypasses the throttle. Due to the transmission of additional air modulator adjusts the engine speed to idle.

Check

PERFORMANCE ORDER

  1. Disconnect the connector from the modulator frequency control idling.
  2. Measure the resistance between the connector terminals. Resistance between terminals 1 and 2: 10,5-14 Ohm resistance between terminals 2 and 3: 10-12.5 ohms at 20 ?� C.
  3. Connect to the modulator frequency control idling.




« previos page
Fuel injectors
next page »
Vehicle speed sensor (VSS)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.