printable version
Adjusting the axial clearance pinion
Disconnect the field coil wire from terminal "M" pulling the relay.
| Fig. 7.56. Driving adjust the axial clearance of the pinion
|
Connect the wires from the terminals 12 V battery (via a switch) to the terminals ?�S?� (+) and ?�M?� (-) magnetic switch (Fig. 7.56). Set the switch to "ON." In this case, the starter pinion gear pops forward until it stops.
ATTENTION This test must be carried out quickly, no more than 10 seconds, to prevent the coil from burning starter. |
With the probe measure the axial clearance between the pinion gear and the limiting ring. If the axial clearance does not correspond to the nominal values range, adjust it by installing or removing shims between the traction relay and the starter front bracket (Fig. 7.57). Nominal backlash: 0,5-2,0 mm.
|