REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
			general information
			Care body
			Care made of vinyl trim panels
			Care of an upholstery and rugs salon
			Repair minor damage to body panels
			Repair of considerable damages of a body
			Service hinges and locks
			Replacing windscreen and motionless glasses
			Removal, installation and adjustment of position of a cowl
			Removing and installing bonnet cable and its drive
			Removing and Replacing the decorative panel grille
			Removal and installation of a forward wing
			Removing and installing bumpers
			Removing and installing interior door trim panel
			Removal, installation and adjustment of the position of the door
			Removal and installation of handles, cylinder lock (latch) the door lock
			Removing and installing window glass doors
			Removing and installing door window regulator
			Removing and installing center console
			Removing and installing tailgate trim panel
			Removal, installation and adjustment of the position of the tailgate
			Replacing the tailgate stops
			Removal and installation of facing of the instrument cluster
			Removal and installation of facing dashboard
			Removing and installing dashboard
			Removal and installation of covers of the column cover
			Removal and installation of rear-view mirrors
			Remove the cowl grille and installation
			Removal and installation of seat
			Control body sizes
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Removal, installation and adjustment of the position of the door

PERFORMANCE ORDER

Remove the interior door trim. Disconnect the electrical connectors and push them to the wiring harness through the hole in the door, so they do not interfere with the removal of the latter.

Disconnect the electrical connectors (arrows) and remove the harnesses from the door.

Get under the door of a jack or ask the assistant to hold it and proceed to remove the bolts hinges.

When using the jack lay between his head and the surface of the door to protect paint rags.

Marker circle head bolts, and then take the bolts and gently pull them out of the door.

Before removing the door marker, mark the installation position of the bolt heads on the plate loop.

Install in reverse order. Make sure the correct location of the loops in accordance with those made in the process of dismantling the labels. Verify the absence of the need to adjust, tighten the bolts.
After installation, check that the doors of its provisions, if necessary, adjust the position of the hammer lock.

« previos page
Removing and installing interior door trim panel

next page »
Removal and installation of handles, cylinder lock (latch) the door lock