REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
			general information
			Care body
			Care made of vinyl trim panels
			Care of an upholstery and rugs salon
			Repair minor damage to body panels
			Repair of considerable damages of a body
			Service hinges and locks
			Replacing windscreen and motionless glasses
			Removal, installation and adjustment of position of a cowl
			Removing and installing bonnet cable and its drive
			Removing and Replacing the decorative panel grille
			Removal and installation of a forward wing
			Removing and installing bumpers
			Removing and installing interior door trim panel
			Removal, installation and adjustment of the position of the door
			Removal and installation of handles, cylinder lock (latch) the door lock
			Removing and installing window glass doors
			Removing and installing door window regulator
			Removing and installing center console
			Removing and installing tailgate trim panel
			Removal, installation and adjustment of the position of the tailgate
			Replacing the tailgate stops
			Removal and installation of facing of the instrument cluster
			Removal and installation of facing dashboard
			Removing and installing dashboard
			Removal and installation of covers of the column cover
			Removal and installation of rear-view mirrors
			Remove the cowl grille and installation
			Removal and installation of seat
			Control body sizes
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Removing and installing center console

See. The warning at the beginning of Section Removal and installation of decorative panels in place of the grille.

PERFORMANCE ORDER

Disconnect the negative wire from the battery.
Remove the cup holder.

Remove the console cupholder.

Remove the gear lever knob, firmly grasping it and pulling it up.

Firmly grab the gear lever knob and pull up sharply, taking off from the stem of the lever.

Having hooked, remove the panel position indicator transmission

Release and remove the position indicator transmission.

Give fixing screws / bolts, separate console and lift it up.

Details of installation of full length floor console.

Details of installation of the floor console truncated type.

Disconnect the electrical connectors and remove the console from the vehicle.
Install in reverse order.

The top (ceiling) console

PERFORMANCE ORDER

Give the front screws fastening console and disunite an electric socket on-board computer.

Details of installation of the top (roof) of the console.

Move forward console, remove it from the bracket and lower so that there was the possibility of disengaging the electrical connections by disconnecting them completely remove the upper console of the car.
Give fixing screws and separate the console from the rear half.
Install in reverse order.

« previos page
Removing and installing door window regulator

next page »
Removing and installing tailgate trim panel