REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
			general information
			Starting the engine from the auxiliary power
			Check and replacement of wires of the battery
			Removing and installing battery
			Ignition System - general information
			Check of serviceability of functioning of the ignition system
			Check of serviceability and replacement of the ignition coil
			Check of serviceability and replacement of the camshaft position sensor
			Removal and installation of the distributor
			Charge system - the general information and precautions
			Check of serviceability of functioning of charge
			Removing and installing the generator
			Starting system
			Troubleshooting starter without removing it from the car
			Removing and installing starter
			Removal and installation of the traction relay (engines of 4.0 liters)
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Removing and installing battery

If the vehicle is put on non-use (the engine will not start) for more than 20 days, remove the IOD fuse in the power distribution center in order to avoid excessive battery discharge.

PERFORMANCE ORDER

Disconnect from the battery both wires.

First, always disconnect the negative cable from the battery to prevent accidental short circuit of give positive terminal clamp.

If the radio in your car is equipped by a security code before to disconnect the battery negative cable, make sure that you know this code.

Remove the battery clamp.

Give two nuts (arrows), and then remove the battery clamp.

Remove the battery thermofilter.

Remove the battery. Be careful - it weighs a lot.

The shops of automobile accessories at a reasonable price, you can buy special, equipped with handles to facilitate the bandages removing the battery from the vehicle.

After removing the battery, check the status of the holder (pallet) (for signs of corrosion or other damage).
If corrosion is switched to the battery bracket, give the bolts and remove the bracket. Shoe support using a solution of baking soda will help prevent the bracket from further oxidation.

The components of the pallet and the clamping plate of the battery.

If the battery needs to be replaced, be sure the battery to re-acquired by the design, size and output characteristics correspond to replace.
Install in reverse order.

« previos page
Check and replacement of wires of the battery

next page »
Ignition System - general information