 printable version
Transfer case
Difficult switch box to the desired mode - Vehicle speed can be too large for the desired switching. Stop the car and switch box.
- Bent or jammed or bent shift eased her mount. Check cravings for signs of wear or damage, if necessary, make lubrication or replacement of components (Head Automatic transmission).
- After driving for a certain time, the paved surface switching torque transmission lines may occur with difficulty. Stop the vehicle and set it in motion mode nepolnoprivodnoy the paved surface or on the road.
- The box is filled insufficient amount of oil, or oil is not of the sort. Empty the box and fill it with oil of the desired variety (Head of Adjustment and routine maintenance).
- There is a deterioration of or damage to the internal components of the transfer case. Perform disassembly and overhaul of the box (Head Automatic transmission).
The transfer case there are noises while driving in all gears The box is filled insufficient amount of oil, or oil is not of the sort. Empty the box and fill it with oil of the desired variety (Head of Adjustment and routine maintenance). There is jumping out of the transfer case AWD mode to the low gear - There has been no full engagement in the transfer case. Stop the car, put the transmission / gearbox in neutral and then select 4L (four-wheel drive, low gear).
- Worn or jammed or bent shift eased her mount. Tighten fasteners or make the necessary repairs or lubrication of the respective components.
- Crack fork switch, worn insert or plug jammed. Make the necessary repairs and disassembly (Head Automatic transmission).
We have the oil leakage through the vent seals or secondary (output) shaft - Distributing box overflowing with oil. Drain the excess, bringing the level to normal (Head of Adjustment and routine maintenance).
- Blocked vent path or stuck valve. Clean or replace the vent path
- Improperly installed or damaged gland secondary (output) shaft. Using sandpaper or fine grinding stone to remove burrs.
|
