REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Design Features
			Replacement bumpers
			Removal and installation of a mudguard and front wheel arch liner
			Removing and installing the rear wheel mudguard
			Removal and installation of a forward wing
			Removing and installing bonnet
			Door
			The trunk lid
			Removal and installation of facing the boot
			The fuel filler flap
			Seats
			Supplemental Restraint System
			Rear view mirrors
			Dashboard
				Removal and installation of the glove compartment
				Removal and installation of facing of the upper instrument panel
				Removal and installation of the left lower trim dashboard
				Removing and installing the side facing the dashboard console
				Removal and installation of the right lower instrument panel trim
			Removal and installation of the instrument panel
			Heater and air conditioning
			Interior fittings
			Replacing a windscreen
			Care body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

Removal and installation of facing of the upper instrument panel

You will need a screwdriver with a flat blade and Phillips.

1. Disconnect a wire from the plug ?�-?� the storage battery.


2. Remove the two screws fastening the upper facing the instrument panel.	3. Use a screwdriver with a screwdriver wrapped with insulating tape, pry off the trim on the left side at the top ...


4. ... and the lower part.	5. Similarly, pry the trim on the right side ...


6. ... and overcoming the resistance of latches, remove the trim from the dashboard.	7. Remove the four screws that secure the cap space for the radio ...

8. ... disconnect the plug harness pads and remove the plug.

9. Disconnect the wiring harness from the control unit exterior rear-view mirrors and the regulator electroproof headlights (see. "Replacement of the control unit exterior rear-view mirrors and headlights electroproof regulator").


10. Disconnect the wiring harness from the switch rear fog lights ...	11. ... the switch located above the place for radio ...


12. ... and on hours.	13. Disconnect the wiring harness from the control unit with heating and air conditioning ...

14. ... and remove the dashboard trim.

15. Install the upper trim panel of devices in the reverse order of removal.