REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Design Features
			Replacement bumpers
				Removing and installing front bumper and dismantling
				Removing and installing rear bumper, his amplifier and their attachment brackets
			Removal and installation of a mudguard and front wheel arch liner
			Removing and installing the rear wheel mudguard
			Removal and installation of a forward wing
			Removing and installing bonnet
			Door
			The trunk lid
			Removal and installation of facing the boot
			The fuel filler flap
			Seats
			Supplemental Restraint System
			Rear view mirrors
			Dashboard
			Removal and installation of the instrument panel
			Heater and air conditioning
			Interior fittings
			Replacing a windscreen
			Care body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

Removing and installing rear bumper, his amplifier and their attachment brackets

You will need: a screwdriver with a flat blade and Phillips, the key "10" socket wrench "14".

1. Disconnect a wire from the plug ?�-?� the storage battery.

2. Remove the rear lights (see. "Replacing the rear light").

3. Remove the rear mud flaps wings (see. "Removing and installing the rear wheel mudguard").

4. Remove the fasteners securing the top six caps bumper ...

NOTE

Since the pistons are arranged top-fixing bumper.


5. ... and remove the caps.	6. Disconnect the harness connector from the fog lamp findings.

7. Remove the rear and the side facing the boot (see. "Removal and installation of facing the boot").


8. Disconnect the wiring harness connector license plate light and push the harness through the hole on the body.	9. Remove the plastic retainers ...

NOTE

Since the pistons are arranged bumper lower mounting.


10. ... and remove the four pistons the lower the bumper-to-body.	11. Remove one screw securing the rear bumper to the wing.


12. Remove the one bolt fixing the bumper to the body on both sides.	13. Disconnect from the bracket on the body clamps bumper underneath it ...


14. ... and remove the rear bumper of the car.	15. Remove the four screws on each side ...


16. ... and remove the amplifier from the vehicle bumper.	17. Lift the trunk floor mat, remove the two bolts ...

18. ... and remove the bumper brackets and the amplifier.

19. Install the rear bumper, his amplifier and brackets attaching them in the reverse order of removal.