 printable version
Replacing the power steering pump
If the pump fails, replace it in the collection, as repair requires special tools and equipment. You will need: pliers, wrenches, "12", "14", "22", a hammer. | | 3. Turn the adjusting bolt ... | ... 4. Remove the nut fastening of the pump to an adjusting lath ... |
| | 5. ... remove the bolt and remove the slide tensioner. | 6. Remove the bolt-fitting mounting the high pressure pipe to the union the power steering pump ... |
| 7. ... and disconnect the piping. |
A WARNING Take measures to prevent leakage of hydraulic fluid from the pipelines, drowning them, such as wooden plugs. |
| | 8. Remove the screw-fitting the tip of the high pressure pipe and remove the seals. Highly crimped or deformed, replace the gasket. | 9. Slide the protective cover wire tip pressure sensor system, power steering ... |
| 10. ... and disconnect the wires from the sensor tip. |
NOTE The pressure sensor in the power steering almost never fails. If necessary, replace it by disconnecting the sensor wire, remove the sensor from the pump housing and screw the new one. |
| | 12. Remove the three bolts securing the bracket power steering pump to the engine block ... | 13. ... and remove the pump assembly from the bracket. |
| | 14. Through the hole in the pulley of power steering pump, remove the bolt the pump to the bracket ... | 15. ... remove the bolt ... |
| | 16. ... and remove the bracket. | 17. Carefully inspect the bushing in the bracket. Badly worn, replace the plug. To do this, knock it with a hammer ... |
| 18. ... and the press in the new bushing mandrel of suitable size. |
19. Install the power steering pump in reverse order of removal. |
|
