 printable version
Installing the mounting bolt crankshaft pulley
| Fig. 2.86. Installation of a special device on the camshaft
|
Install the special tool on the camshaft (see. Fig. 2.86).
| Fig. 2.113. Locking the crankshaft pulley bolt: 1 - a bolt
|
Install the retaining bolt and tighten it M6x1,0 hand (Fig. 2.113). Turn the crankshaft clockwise to the TDC Piston ?��1.
| Fig. 2.104. Installing the special tool on the crankshaft: 1 - SPECIAL TOOLS
|
Tighten the mounting bolt crankshaft pulley in two steps: Tighten the bolt to 96-104 Nm; Tighten bolts of 87-93 ?� Remove the bolt M6x1,0. Remove special tool with camshaft. Remove the special tool from the hole bottom cap cylinder. Rotate the crankshaft clockwise two turns until the TDC Piston ?��1. If TDC can not be achieved, loosen the crankshaft pulley bolt and repeat the action again. Replace the bottom of the cylinder plug and tighten it a torque of 18-22 Nm.
| 
