To remove the pre-disk brake pads must be removed as described above. Then unscrew the caliper bracket bolts on the front axle and remove the bracket. The brake disk is fixed to the hub with one bolt, which can be removed by unscrewing the drive. If necessary, you can bring down the disk a rubber or plastic hammer. To keep the drive when you can screw loosening the two nuts on the wheel hub and the two pins set between the mount, as shown in
Fig. 286. Before installing the previous disk read the recommendations in Section. 12.5.3. Installation is performed in reverse order. Bolt drive torque to 20 Nm, the caliper bracket bolts - torque 175-205 Nm.
