 printable version
The turn signal and alarm
If you switch off the ignition switch on the red alarm, all four direction indicators and clear button of the switch will blink in the same rhythm. To check the direction indicators need to turn on the ignition and turn off the alarm, since it covers the work of the direction indicators. When translating the lever in the appropriate position indicator lamps on one side and a green indicator lamp in the instrument cluster should start to light up at regular intervals. Jobs warning device is organized in such a way that according to the prescribed norms alarm works even when the ignition is switched off - the switch voltage is supplied directly from the battery. The turn signals are supplied with power when the ignition is established through the fuse. In the event of faults in the system can be useful the following recommendations: - If the indicator lamp stops working in the normal mode or flashing, as a rule, one of the faulty lamp system; - If the lights stop flashing and are permanently defective relay device; - If it flashes it faster, then slower, and wiring, including wire of "weight" is not damaged, replace the relay; - If the direction indicators when the do not work, but take effect when you turn on the alarm, blown fuse, faulty switch of turn indicators or wiring; - If you do not work blinkers, no alarm, the faulty relay. In addition to the warning lamp flashes in rhythm with incandescent signs, including the system is also supported by an acoustic signal - clicks, which publishes the relay in the instrument panel. When a malfunction must be disassembled the dashboard, which is sufficient time-consuming.
| 
