REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W123
		Introduction
		Gasoline engines
			Design and specifications
			Engine adjustment
			Ignition system
			Power system
			The fuel injection system K-Jetronic
			The fuel injection system L-Jetronic
			Works by car
			Work on the engine M 102
			Work on the engine M 110 and M 123
				Removing the engine M 110 and M 123
				Removing the cylinder head
				Removing the camshaft
				Dismantling of a head of cylinders
				Replacing the chain camshaft
				Removing the intermediate shaft and sprocket
				Removing the flywheel (a leading disk)
				Replacement of a forward epiploon of a cranked shaft
				Removal of the oil pump
				Removing the rods and pistons
				Removing the crankshaft and main bearings
				Changing the oil filter
				Replacing the engine mount
				Description Service and crankcase ventilation system
				General information on inspection and recovery engine
					Inspection and restoration of the crankshaft and bearings
					Inspection and restoration of connecting rods and bearings
					Inspection and restoration of pistons and piston rings
					Inspection and restoration of the cylinder block
					Inspection and restoration of details of the distribution mechanism
					Inspection and restoration of the flywheel (a leading disk) and flywheel
					Inspection and recovery of the oil pump
					Removal of sludge, grinding valves and restoration of cylinder heads
				Build Engine
				Assembling the cylinder head
				Installing the cylinder head
				Installing the cylinder head
				Cooling system
				Removing and installing intake manifold and exhaust manifold
		Coupling
		Manual transmission
		Automatic Transmission
		Driveline and rear axle
		The front suspension
		Rear suspension
		A steering
		Brakes
		Electrical
		Body and Equipment

printable version

Inspection and restoration of the flywheel (a leading disk) and flywheel

PERFORMANCE ORDER

On models with a manual gearbox see whether scoring or discoloration caused by overheating at the contact surfaces of friction flywheel. If they are, pereshlifuyte surface or replace the flywheel.
If worn starter ring gear drive, remove it with a drill or chisel, or rapid heating bring down the hammer.
Heat the new ring gear to light straw color (up to 220 ?� C) and push it to the flywheel, making sure that the bevel teeth located on the side of the engine.

« previos page
Inspection and restoration of details of the distribution mechanism

next page »
Inspection and recovery of the oil pump