|
|
 printable version
Service the throttle cable
Refitting Withdrawal |  | - Loosen the lock nut and remove the cable from the adjuster bracket.
|
- Turn the lever to move the throttle fully open position. Using the resulting slack, disconnect the cable from the lever.
- In the car, release the tabs and remove the plastic sleeve cable from the top of the lever of the gas pedal. Release the lever of the cable core.
- Give bolts cable bracket.
- Pull the throttle cable through the bulkhead engine compartment into the passenger compartment.
- Check the core and shell of the cable for signs of wear, damage to thread and peg. If necessary, replace the cable.
|
|
Setting Installation is in the reverse order. | - To avoid peg careful not to twist the cable and do not bend it too much.
- Track correctness of installation of the sleeve in the upper portion of the gas pedal lever.
|
|
Adjustment | - Make sure that the cable of a manual throttle actuator is fully released.
- Ask the assistant to squeeze out a gas pedal fully and make sure the throttle actuator rod is in the fully open position.
- If necessary, loosen the lock nut and properly Adjust the length of the cable.
- With proper adjustment of the throttle must be fully opened when depressed the gas pedal to the floor.
- Released the pedal should be free stroke 1 ÷ 3 mm. Minor slack should be also drawn to the core of the cable drive throttle on the carburetor.
|
|
|
|
