 printable version
Replacing the brake hose
A warning  Brake hoses may not be in contact with oil or fuel. You also can not cover the brake hoses varnish or other protective structures.
Withdrawal
| PERFORMANCE ORDER | | 1. Loosen the bolts of the front wheel. Tighten a manual brake, then lift the front of the car and fix on supports. Remove the wheel. | | 2. In order to reduce the loss of brake fluid, remove the cap from popolnitelno first tank of brake system, close the mouth of a tank polyethylene and again screw cap. This is necessary in order to cover tightly closed popolnitelny tank. | | 3. Unscrew the bolts and remove the brake caliper. | | 4. Release the brake hose guide and bracket. | | 5. Clean the area around the brake hose couplings and loosen the brake hose. Close the holes in the caliper and the brake line suitable stoppers. |
|
Setting
A warning When installing, use the brake hoses recommended by the manufacturer.
| PERFORMANCE ORDER | | 1. Install the new brake hose, do not twist it and tighten the brake hose fittings torque 15 Nm. | | 2. Turn the steering wheel from lock to lock, check that the brake hose moves freely and does not contact with the elements of the front suspension and bodywork. | | 3. Establish a support. | | 4. Remove the polyethylene filler popolnitelnogo tank and pump over a corresponding brake circuit. | | 5. Establish a wheel and lower the car to the ground. Tighten the bolts in diagonal sequence the moment of 120 Nm. |
|
|
