|
|
 printable version
Brake light switch
Location of the brake switch
| 1 - the switch of a stoplight,
2 - M12h1,5 locknut,
3 - a brake pedal, A = 0.1-0.5 mm |
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the carpet in deepening for feet of the driver. | | 2. Disconnect the electrical connector from the brake light switch (see. Fig. Location of the brake switch). | | 3. Loosen the lock nut and remove the brake light switch from the brake pedal bracket. Save the snap ring located between the lock nut and the brake pedal bracket. |
|
Setting
| PERFORMANCE ORDER | | 1. Screw the brake light switch to the brake pedal bracket so that the distance between the push rod and the brake pedal switch was 0.1-0.5 mm. In this position, the switch tighten the lock nut 5 Nm. When installing the brake light switch brake pedal must be in rest position. | | 2. Connect the electrical connector to the brake light switch. | | 3. Check the operation of the brake light switch. Even with a slight pressing on the brake pedal brake lights should illuminate. | | 4. Replace the carpeting in deepening for feet of the driver. |
|
|
|
