REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
			Lubrication system
			Cooling system
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
				Compression Test
				Removing Engine
				Installation of the timing belt
				Valve Actuator
				Removal and installation of camshafts
				Replacing the valve stem seals (if installed cylinder head)
				Replacement exhaust camshaft oil seal
				Removal and installation of the phase shifter
				Removing and installing valve 1 control valve timing
				Removing and installing V-ribbed belt
				Replacing crankshaft oil seal on the side of the pulley
				Removing and installing sealing flange on the side of the pulley
				Removal and installation of the flange on the side of the crankshaft flywheel
				Removal and installation of a flywheel
				Removing and installing drive plate
				Crankshaft
				The pistons and connecting rods
				Checking the pistons, piston rings and cylinder bore
				Removing and installing cylinder head cover
				Removing the cylinder head
				Installing the cylinder head
			Lubrication system
			System ohlazhdeiya
			Fuel system
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

The pistons and connecting rods

Fig. 2.154. Piston and connecting rod: 1 - connecting rod cap bolt, 30 Nm + to tighten on 1/4. (90 ?�); 2 - the pressure reducing valve 27 Nm; 3 - Oil injection nozzle; 4 - a cover of a rod; 5 - bearing; 6 - a connecting rod; 7 - a lock ring; 8 - piston pin; 9 - piston; 10 - the piston rings

Fig. 2.155. Mounting position inserts

The bearing shells

One bearing hole for the lubricating oil passage connecting rod.

Bearing shell 2 without hole for the connecting rod cap.

Insert bearing shells in the connecting rod and the connecting rod cap in the middle.

Size A should be the same on the left and right.

« previos page
Crankshaft

next page »
Checking the pistons, piston rings and cylinder bore