 printable version
Replacement of the crankshaft oil seal on the side of the timing of the engine
The order of execution of works
Carefully remove the old seal ring using puller T20143 / 2 (Fig. 2.177).
NOTE When removing the oil seal, make sure that the landing surface was not damaged. |
Remove the remaining oil on the crank pin of the crankshaft with a clean cloth.
Connect the mounting sleeve T10207 / 1 and the mounting sleeve T10207 / 2. Put the oil seal A to stop the mounting sleeve T10207 / 2 (Fig. 2.175). Disconnect the mounting sleeve. Install the mounting sleeve T10207 / 2 together with the gland seal on the crankshaft and tighten the thumbscrews A by hand.
Fitting the seal with the mounting sleeve T1207 / 3 to the stop (Fig. 2.176). Further installation is performed in reverse order.
| 
