add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Transmission
-speed automatic transmission 09D
Check the torque converter
Manual transmission and transfer case 08D E473
Marking the transfer case
Marking the front of the main transfer
Marking the back of the main transfer
General information
Electrical / electronic components and fitting locations to dropbox
Removal and installation of the management body transfer case E473
Removing and installing transfer case control unit J646
Remove the transfer case
Install the transfer case
Laying the ventilation tube to dropbox
Replacing the rubber bearing bracket Transmission
Checking the oil level in the transfer case
Removing and installing sealing ring flange PTO / PTO drive shaft and motor transfer case
Changing the O-ring flange PTO / rear propeller shaft (transfer box set)
Removing the motor transfer case V253
Installing the motor transfer case V253
Checking the oil level in the main transmission of the front axle
The propeller shaft
Drive Train
Tables
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Changing the O-ring flange PTO / rear propeller shaft (transfer box set)



Withdrawal
Remove the rear driveshaft.

Pressing gland
Fig. 2.121. Pressing gland


Loosen flange nuts PTO (Fig. 2.121).
A - Hexagon bolt M 10x30 with nuts.
Remove the flange PTO.

Removing the O-ring flange PTO / rear propeller shaft
Fig. 3.111. Removing the O-ring flange PTO / rear propeller shaft


Remove the seal ring with a general purpose tool VW 771 and puller VW 771/37 (Fig. 3.111).
Clean the threads of the screws.

Setting
Fill the space between working with the dust and sealing lips half with grease G 052 128 A1.

Pressing the O-ring flange PTO / rear propeller shaft
Fig. 3.112. Pressing the O-ring flange PTO / rear propeller shaft


Fitting the new sealing ring to the end, while it is not skewed (Fig. 3.112).
Install flange PTO.
The new O-ring soak in gear oil and install.

The new O-ring
Fig. 3.119. The new O-ring


Figure 3.119 shows the O-ring on the flange PTO / front propeller shaft.
Grease the threads of the new screws nail fixing Loctite 648.

Gaki flange PTO
Fig. 3.121. Gaki flange PTO


New flange nuts PTO screw tightening torque (Fig. 3.121).

Fixing nuts on the flange PTO / rear propeller shaft
Fig. 3.120. Fixing nuts on the flange PTO / rear propeller shaft


Fasten the nuts on the specified places (eg mandrel) (Fig. 3.120).
Install the rear propeller shaft
Check the oil level in the transfer case
Torque: flange nuts PTO to PTO 130 Nm.




« previos page
Removing and installing sealing ring flange PTO / PTO drive shaft and motor transfer case
next page »
Removing the motor transfer case V253

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.