|
|
 printable version
Removal, installation and adjustment of doors
Fixing the door | 1. Nut
2. Hexagonal screws |
Withdrawal
| PERFORMANCE ORDER | | 1. Unscrew the nut (1) and remove your finger. | | 2. Unscrew the hex screws (2) from the upper and lower hinge and remove the door. If the door will be installed again, to outline the screw heads marker. This will facilitate the assembly. |
A warning  On machines with special equipment, such as central locking, electric windows, electrical and heated outside mirror and loudspeakers in the doors: disconnect the power cable and remove the door to remove the lining of the door.
|
|
Setting
| PERFORMANCE ORDER | | 1. Set the door to the hinges and screw by hand. | | 2. Screw the nut (1) stop the doors 7 N ?� m. |
|
Adjustment
| PERFORMANCE ORDER | | 1. Adjust the door is always required when installing a new door. When adjusting should pay attention to the same parallel to the size of the groove around the perimeter of the door relative to the body and the surrounding parts. | | 2. Adjust the front of the door: loosen the screws of the hinges (2) and adjust the door (see. Fig. Mount the door), moving it into the hole openings enlarged joints. | | 3. Fit the door on the contour of the body. At the same grooves doors should match the grooves of the wing. | | 4. To avoid wind noise door move inwardly or outwardly, until the upper surface thereof is aligned with the front fender. Front door to be recessed relative to trimming the wing is not more than 1 mm. | | 5. Tighten the screws to 55 Nm. | | 6. At the rear of the door adjustment is made with respect to the locking pin. For ease of locking pin so that it can move with the application of force. Close the door and fit. Then carefully open the door and tighten the locking pin. |
|
|
|
