REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Transporter, Caravelle (1990 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Transporter / Caravelle
		Instructions
		Engine
		Coupling
		Transmission
		Suspension
		A steering
		Brakes
		Wheels and tires
		Body
		Electrical
			Electrical system
			Installation of additional electroaccessories
			Troubleshooting in electrical equipment
			Relay
			Wiper motor
			System of indexes of turns
			Stop signal
			Sound signal
			Heated rear window
			Replacing fuses
			Accumulator battery
			Warning lights
			LEDs
			Voltage regulator
			Switchgears
			Roller speedometer
			Generator
			Starter
				Removing and installing starter
				Magnetic relay
				Troubleshooting Starter
			The lighting system and alarm
			Wiring

Removing and installing starter

Protection () cable from the battery to the starter

The arrow indicates the protection of the cable.

Wiring harness starter

Wiring harness starter arrow.

Withdrawal

PERFORMANCE ORDER

1. Turn off the ignition.
2. Disconnect the earth cable (-) from the battery.
A warning When disconnecting the battery erased the memory of the radio and the electronic control units. If the radio is coded, before disconnecting the battery to record radio code. Without entering the security code, radio, after connecting the battery will not operate.
3. Set the machine on the stand.
	4. unscrew the wire from terminal 30 (1) of the battery - the starter and starter - generator. Disconnect 50 (2) to the ignition lock.
	5. Unscrew the screws from the gearbox mounting starter (indicated by arrows). This requires a special key.

Setting

PERFORMANCE ORDER

1. Set the starter, tighten the screws 3 to 20 Nm, but not very much.

2. Secure the wire to the terminal 30 to 15 N ?� m.

3. Connect the cable to terminal 50.

4. Put on the plastic cover.

5. Connect the earth cable (-) to the battery.

A warning

The battery connected only when the ignition is switched off, otherwise the possible failure of the injection system control unit.

6. Set the time on the clock.

7. Put in place anti-theft radio code.

« previos page
Starter