add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Transporter, Caravelle (1990 release)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Transporter / Caravelle
Home
 
Volkswagen
Transporter / Caravelle
Instructions
Engine
Coupling
Transmission
Suspension
A steering
Brakes
Wheels and tires
Body
Electrical
Electrical system
Installation of additional electroaccessories
Troubleshooting in electrical equipment
Relay
Wiper motor
System of indexes of turns
Stop signal
Sound signal
Heated rear window
Replacing fuses
Accumulator battery
Warning lights
LEDs
Voltage regulator
Switchgears
Roller speedometer
Generator
Check the generator voltage
Removing and installing the generator
Replacing the carbon brushes of the generator and check the voltage regulator
Troubleshooting generator
Starter
The lighting system and alarm
Wiring
 


Hit Counter by Digits


print page printable version

Replacing the carbon brushes of the generator and check the voltage regulator



Generator BOSCH

The arrow indicates the location of the voltage regulator.

Alternator VALEO

The arrow indicates the location of the voltage regulator.

Depending on the equipment can be installed generators of various companies. Removing the carbon brushes have generators and BOSCH VALEO possible during a generator. The length of the new brushes is 12 mm.

Withdrawal

PERFORMANCE ORDER
1. Disconnect the earth cable (-) from the battery.

A warning

When disconnecting the battery erased the memory of the radio and the electronic control units. If the radio is coded, before disconnecting the battery to record radio code. Without entering the code, after connecting the battery, the radio will not operate.


2. Unscrew and carefully remove the voltage regulator on the back side of the generator (2 screws).
3. Replace graphite brushes, if the length is 5 mm or less, a sealed off before the core wire.
4. Check the wear of the collector, if necessary, machined and sanded.
5. Clean the contacts, check the contact springs, replace weakened.

Setting

PERFORMANCE ORDER
1. Set graphite brush (A) and the spring (B) in the brush holder (P) and solder connections.
2. For the soldering of new graphite brushes solder is ranked high on stranded wire, hold it flat mites.

A warning

Climb high solder does stranded wire and rigid graphite brushes are not working.


3. izolirovochnyh stranded wire hose must be fixed near the site of the solder from the existing springs.
4. After installing the new graphite brushes, easy to check the progress of their brushes in the holder.
5. The voltage regulator to fix the beginning of the hand of one screw, then carefully set into place and fasten completely.
6. Connect the earth cable to the battery.

A warning

The battery connected only when the ignition is switched off, otherwise fail control unit injection system.


7. Set the clock.
8. Enter the anti-theft radio code.




« previos page
Removing and installing the generator
next page »
Troubleshooting generator

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.